Updated November 2026
Putting up Christmas inflatables takes about 30 to 60 minutes for a single figure, and the result is a lit, upright display that stays put in ordinary weather. This guide walks through how to put up Christmas inflatables from start to finish: picking a spot, inflating, anchoring and powering the display. Follow the order below and you will avoid the most common reasons inflatables tip, deflate or get damaged.
Choose the Right Spot and Check Your Power
Pick a flat, open area with at least a few feet of clearance on every side. Keep the inflatable away from overhead wires, tree branches and the roofline, since a gust can push a tall figure into them. Before you unroll anything, confirm that your outdoor outlet is working and that you have a GFCI-protected connection. Most manufacturers recommend a weatherproof outdoor extension cord rated for the fan’s wattage, and they advise against daisy-chaining several cords together.
Shopping for one? See our guide: 7 Best Christmas Blow Up Inflatables for Yard Displays (2026).
Unpack, Lay Out and Inflate
Lay the inflatable flat on the ground with the face or front facing up. Remove the stakes, tethers and fan, and check the fabric for creases or damage before you start. Connect the blower to the base opening, then switch it on. Most figures take several minutes to fill fully, and you should wait until the body is firm and upright before you adjust the position. Avoid running the fan with the blower facing a wall or a tight corner, because restricted airflow can overheat the motor. If you want more background, see How to Set Up Chafing Dishes Safely.
Anchor the Display So It Stays Upright
Anchoring is the step that matters most. Use the stakes or tie-down straps that came with the figure, and place them at every tether point. Drive stakes at an angle away from the inflatable so the pull of the tether tightens the stake into the ground rather than lifting it out. In soft or sandy soil, add weights to the base as well. For a detailed walkthrough on this, see Weights for Christmas Inflatables: How to Anchor Yard Displays Safely and How to Tie Down Christmas Inflatables Safely: A Step-by-Step Guide (2026).
Check the Tension
Once the figure is up, gently push the top and sides. It should spring back without leaning. If it tilts, tighten the tethers in small increments rather than making one large adjustment.
Power the Display and Plan for Weather
Run the fan cord along the ground and secure it so nobody trips on it. Tape or tuck the cord near the base, and keep connections off wet grass. Lights and fans should be unplugged during high winds, heavy rain or freezing conditions, because a sudden power loss can cause the figure to collapse quickly. If you expect bad weather, read How to Secure Christmas Inflatables in Wind and Bad Weather before the season starts.
Recommended gear
- Heavy-duty ground stakes: Longer stakes hold better in lawns that stay soft after rain. View on Amazon
- Outdoor GFCI extension cord: A weather-rated cord with GFCI protection reduces shock risk on wet ground. View on Amazon
- Inflatable tie-down straps: Adjustable straps give you a second anchor point when stakes alone are not enough. View on Amazon
Common Mistakes
- Skipping the tethers because the figure looks stable while the air is still settling.
- Driving stakes straight down instead of at an angle away from the base.
- Running the fan on a damaged or non-weatherproof extension cord.
- Leaving the display on overnight during storms or strong winds.
- Storing the figure while still damp, which invites mildew in the fabric.
FAQ
How long does it take to put up a Christmas inflatable?
A single figure usually takes 30 to 60 minutes, including unpacking, inflating and anchoring. Larger or multi-piece displays take longer, so plan a few hours for a full yard.
Can I set up an inflatable on a windy day?
It is safer to wait for calmer weather. Strong gusts can lift a partly inflated figure, so set up on a still day whenever you can.
Should I leave my inflatable up all winter?
Many owners take them down during prolonged freezing rain or snow, since moisture can damage the fabric and motor. Check the manufacturer’s guidance for your model and confirm the care details before leaving it outdoors.
Conclusion
Choosing a flat, clear spot, inflating fully and anchoring every tether point will do most of the work of keeping your display upright. Check the tension after setup and keep power connections dry and secure. Follow these steps and your inflatables will look sharp all season.


Write Your Review
No reviews yet. Be the first to share your experience!